STEP
ONE: Verify Contents 1)
Box should contain: Cisco 678 ADSL router, Quick
Start for the Cisco 678 ADSL Router, Cisco 678
ADSL Router Installation and Operation Guide,
Cisco Broadband Operating System User Guide,
Power supply, telephone cable, and Ethernet cable.
If you are missing any of these items, call toll
free 866-764-8485 prompt 1.
2) Take the telephone micro-filters and install them on your telephones. The
in-line filters are plugged into the telephone jack, and the telephone is plugged
into the micro-filter. The wall telephone micro-filter is installed by removing
the telephone from the existing modular wall jack by pushing the telephone in
an upward direction until it is freed from the wall jack. The wall micro-filter
is then installed on the existing wall jack and the telephone is replaced on
the micro-filter. STEP
TWO: Hardware Installation 1)
Open the router box and take out the router,
power supply, Ethernet cable, and telephone cable.
2) Plug the Ethernet cable into the router and the Network Interface Card (NIC)
in the back of your PC.
3) Plug the telephone cable into the router and the telephone jack.
4) Plug the power supply into the router and the wall outlet.
STEP
THREE: Software Modification 1)
Click on “My Computer” and open
up Control Panel.
2) Select “Network”
3) Find “TCPIP…10/100” Ethernet Card and double click.
4) Under “Properties”, select “IP Address” tab.
5) Select “Obtain IP Address Automatically”.
6) Click “OK”
7) Select DNS Configuration tab and remove any DNS settings.
8) Click OK. Until you get back to Control Panel.
9) Select Internet Options.
10) Select “Connections” tab.
11) Set to “Never Dial A Connection”. Click OK
12) Reboot your PC.
|
